Big Block Buick Factory timing cover forced us to do things a little different in the design of this pump. Pump center-section is unique to this model: use part # WP156 for replacement.

Coverage for Oldsmobile V8's is easy. All Big Block, Small Block, Corporate and Diesel engines after 1965 share the same water pump. The pump bolts to the factory timing plate with hardware and gasket provided. *Pass side inlet only. Use WP2175 Inlet

Fire wall mounted. Stud / threads: 1/2" / 13. Four mounting holes of 7/32" diameter. Stud height is 1-1/2"

Use these fittings to finish off your custom brake system. The Bolt Down Tee has 3/8-24 thread on the sides and 3/16 I.F. on the run. The Inline Tee has -3 AN male fittings on each end and a 1/8NPT on the side for a brakelight switch or pressure gauge.

Use these recovery tanks with your stock or custom radiator. They look great and come with an o-ring seal on the cap for a leak free seal. 1/8th" NPT ports and 28oz capacity.

Replace that ugly cast factory inlet with this billet aluminum unit.

Pre-made Relay harness. Molded base 5-pole socket. Manufactured with 14ga. wire leads with approximately 19" of lead wire. 40/60 amp, 12 volts D/C.

The best solution for full voltage applications to head lamps, auxiliary lamps, fog horns, motors for fans, pumps or power window motors

These Inline fuse holders have a weatherproof cover that snaps down tight. The "Mini" fuse holder has 12ga wire. 30 amp, 32 volt max. For Mini fuses only (fuse not included). The "Maxi" fuse holder uses 6ga wire to handle 20-80 amp fuses (not included).

Mounts into 1/2" hole. 12 volt DC, rated at 3 amps. Available in 4 colors.

These mini round rocker switches are compact and aesthetically pleasing. Suitable for 12 volt, 10 amp circuits. Mounts in .79" hole

Reliability is how Meziere made their name. Although Failures are uncommon they do occasionally happen. Keep one of these replacement center sections as a back up.

The performance enthusiasts driving and racing the powerfull GM 3800 demanded better cooling. Meziere brings the solution. Better cooling and great looks! Installation requires a 4" shorter belt. For best results use our "Relay kit".

The original Exhaust Insulating Wrap was developed over 12 years ago by Thermo-Tec. Exhaust Insulating Wrap is an innovative way to create more horsepower and reduce under-hood temperatures. Wrapping headers maintains hotter exhaust gases that exit the system faster through decreased density. Increased exhaust scavenging is produced, along with lower intake temperatures. Exhaust Insulating Wrap withstands continuous heat up to 2000°F, and contains no asbestos.

Steel 90* AN to Pipe thread Adapters

Our 6061 T6 Aluminum Tubing is 16 gauge (unless noted) for light weight. Great for Cold Air kits and Intercooler piping. Also can be used for exhaust systems on Race cars. Call for lengths over 4'.

Aluminum Mandrel Bent Elbows for any need. Most sizes are 16 gauge (.065") for light weight cold air piping. Other thicknesses shown in drop down box. Leg lengths are twice the diameter. (ex. 2" elbow has 4" legs on each end)

Just like our popular "Bolt-on" pump for the pre-94 5.0 stangs these new pumps bolt right on and use the factory belt routing. Pump also available without pulley. Please call.